Springfield Airsoft
General Category => DIY => Topic started by: Rockstar on February 11, 2014, 07:55:01 PM
-
Okay so I came across this image :
(http://standupforamerica.files.wordpress.com/2011/02/pimped-out-1422-barrel.gif)
And I love the way that is set up and I want to recreate it. However, if I were to do so, I would want to do it with the tri-burst shotguns. The problem is, getting a stock like the one shown, and getting the rail like the one shown going across the length of the barrel and then getting them to fit. So for all you DIYers, throw some ideas out there. I really want to make this happen.
-
Okay, so after doing quite a bit of looking around, I have found this project will be much simpler going another route. I am pretty sure if I can get the ACM M500 shorty and buy an aftermarket stock for the real M500 I can attach it. All that is left then, is the upper rail which can be attached fairly simply.
-
I started to donl the same and changed up some, pics on here hard to do but some on the fb page I got a rail on mine and working on another ksg style, but good one ya for going all out
-
Thanks! I figure after all the components are ordered, it'll be around $250. That's really the only problem lol. But it'll be awesome! I also saw someone who put a bullpup kit on their real M500 so I am half tempted to try and fit one onto an airsoft version lol.
-
Can't hurt to try. Keep us posted on your progress.
Jon
So Go Airsoft
-
Yeah I will! It's a nix on the bullpup idea though. It's cool, but not $350 (for the kit alone) cool.