Springfield Airsoft
General Category => Reviews => Topic started by: Princess on October 23, 2010, 08:29:20 PM
-
I dont know where to put this but one of the 2 mags (the spare to be exact) that came with my replica sticks. it is hard to put in but works fine then i have to push down on it from what would be the shell ejection while pressing the release to eject the mag. other than that it was a great purchase. cant wait to use it in an op. but this extra mag problem might make it hard to enjoy. Any help would be appretiated
-
Hard without seeing exactly what it is doing. Seems odd that it would do that. But with that said. I have seen stranger things and sometimes there is a real easy fix.
Jon
So go Airsoft
-
ive played with it a little and it starts sticking right at the very bottom of the mag right at the last 3mm. there seems to be no difference in the two mags. i dont want to mess with it to much.
-
probably not a bad idea.
Jon
-
Perhaps a shot of silicon spray on the spring of each magazine? Then work the spring to distribute the oil? Won't hurt your mags at all and it's good maintanence.
-
Its not the spring and i sprayed it down already. the mags just stuck in the replica. its odd but it is not horrible.
-
Did you buy the gun new? Are you sure that both mags are completely the same? I would take dial calipers and measure both mags in the same spots. Their has to be a reason one fits better than the other.
The WE is a popular gun, you should be able to find somebody on here that uses the same mags that you could meet up at SOGO. I can always bring my dial calipers next time I drive down if you don't have some available.
-
yes the gun is new.
no i didn't measure they i shall try that.
After some use they both fit nicely and slide out easier.