WE 1911

[Princess]

I dont know where to put this but one of the 2 mags (the spare to be exact) that came with my replica sticks. it is hard to put in but works fine then i have to push down on it from what would be the shell ejection while pressing the release to eject the mag. other than that it was a great purchase. cant wait to use it in an op. but this extra mag problem might make it hard to enjoy. Any help would be appretiated
 

[Supercell]

Hard without seeing exactly what it is doing.  Seems odd that it would do that.  But with that said.  I have seen stranger things and sometimes there is a real easy fix.

Jon
So go Airsoft

[Princess]

ive played with it a little and it starts sticking right at the very bottom of the mag right at the last 3mm. there seems to be no difference in the two mags. i dont want to mess with it to much.

[Supercell]

probably not a bad idea.

Jon

[Joe]

Perhaps a shot of silicon spray on the spring of each magazine?  Then work the spring to distribute the oil?  Won't hurt your mags at all and it's good maintanence.

[Princess]

Its not the spring and i sprayed it down already. the mags just stuck in the replica. its odd but it is not horrible.

[Shifty]

Did you buy the gun new? Are you sure that both mags are completely the same? I would take dial calipers and measure both mags in the same spots. Their has to be a reason one fits better than the other.

The WE is a popular gun, you should be able to find somebody on here that uses the same mags that you could meet up at SOGO. I can always bring my dial calipers next time I drive down if you don't have some available.

[Princess]

yes the gun is new.
no i didn't measure they i shall try that.
After some use they both fit nicely and slide out easier.